Your cart is empty.
Your cart is empty.Combine up to four of these polymer spacers to adjust the length of pull for a perfect fit. Pre-drilled holes to match Pachmayr Recoil Pads, must be fitted to firearm.
JVB
Wednesday, July 16, 2025
Spacer had to be re-drilled to my stock then shaped which came out perfect -- I was not looking for glossy black finish so this spacer did the job. I'm more for functionality than a fashion show.
got to go
Tuesday, June 24, 2025
These recoil pads are the main line of never fail recoil pad because you grind to fit your self. I'm very particular about the matching of the recoil pad to the butt stock. With a little patience and some hands on skills you can up grade the appearance of your rifle with a decelerator pad.
Douglas Stevenson
Thursday, June 19, 2025
a plastic spacer made of the correct material, works as designed
nelson regalado
Friday, April 18, 2025
For what it was intended
Dan Hoang
Thursday, April 3, 2025
Easy to grind down to fit. Looks good too, increase Length Of Pull (LOP) another 1/4 inch.
john j
Sunday, February 2, 2025
ok
Bucko43
Thursday, December 19, 2024
Just what I needed for a little extra length.
Tim
Friday, November 29, 2024
Surprised the screw holes lined up for my post ‘98 BPS 12ga 3.5” full engraved receiver. Now it’s just a matter of shaving and sanding it down.
Chad Greene
Wednesday, October 23, 2024
Holes lined up perfectly. Surface was easy to mark for outline in prepping for grinding and sanding.
Recommended Products
$28.50
$ 13 .99 $13.99